Brick, block and stone masonry in Racine, Kenosha and Milwaukee CountyBrick, block and stone masonry in Racine
M.O.E Masonry
A finger pointing at eroded mortar joints on a brick chimney above a shingle roof, chimney tuckpointing
Our Services

Chimney Tuckpointing in Racine, WI

Chimney Tuckpointing · Racine, WI

Chimney joints repointed with mortar matched to the old

Chimney tuckpointing is the repair for open, sandy or crumbling mortar joints on a brick or stone chimney. We grind or rake out the worn mortar, then pack in new mortar matched in color, texture and strength. That goes for the stack above the roof and the chimney down the side of the house. Masons also call it chimney repointing, and some write it as chimney tuck pointing.

M.O.E Masonry is based in Mount Pleasant on the south side of Racine. We do chimney tuckpointing in Racine, Kenosha, Pleasant Prairie and the towns around them. Crowns, caps and rebuilds fall under chimney repair, which we also do. Call or text (262) 744-4688, and we will look at the chimney and put the quote in writing.

What We Handle

  • Spot repointing or the whole stack, based on how much mortar has worn
  • Worn mortar cut out at least twice as deep as the joint is wide
  • Head joints cleared by chisel, since a grinder there can chip the brick
  • Type N cement-lime mortar on most chimneys, softer lime-rich mortar on old soft brick
  • New mortar matched to the old in color, and no stronger than the old
  • Spalled brick cut out and replaced in the same job
  • Stacks above the roofline and chimneys down the side of the house
  • A written quote after we look at the chimney or see your photos

Request a Chimney Tuckpointing Quote

Tell us about the wall, chimney, foundation or steps and where the job is. We look at it and put the quote in writing.

What are the signs a chimney needs repointing?

Look for bits of mortar or sand in the gutter or on the roof below the chimney. A Brick Industry Association note lists the signs a joint needs repointing. Mortar worn back more than a quarter inch, crumbling mortar, voids and hairline cracks all count. So do gaps between the brick and the mortar.

White staining on the brick is likely efflorescence, salts that water carries to the surface and leaves behind. On an old chimney, the same group ties it to too much water getting in or poor drainage.

Inside, a damp chimney breast or a ceiling stain beside it means water is getting in. Open joints are one way in. A cracked crown is another, and so is the flashing at the roof, which is a roofer's work.

Chimney mortar repair: spot repointing or the whole stack?

Spot repointing fixes only the worn joints and leaves sound mortar in place. It can be hard to tell which joints let water in, though. For that reason, a Brick Industry Association note advises repointing all the joints in the affected area.

A Brick Industry Association note on chimneys says a chimney is at least partly exposed to the weather. Above the roofline, the stack stands in it on every side. When much of the stack has worn, we repoint the whole stack in one job. The roof setup is needed either way.

When only part of a chimney is repointed, the new mortar should match the color of the old. We mix test batches and compare them with the old mortar wet, then again once dry. A badly spalled brick lets water in too, so we cut it out and set a new one. The same matching goes into our tuckpointing on brick walls and foundations.

Chimney tuck pointing on older Racine and Kenosha homes

Census figures show about a third of the City of Racine's homes were built in 1939 or earlier. The median year built there is 1953. In Kenosha, about one in five homes date to 1939 or earlier, and the median is 1970.

Older chimneys may still have their first mortar. A Brick Industry Association note says mortar before the early 1900s was mostly lime, and lime mortar is weaker. New mortar should be no stronger than the old, or the old brick takes the stress and spalls. On old soft brick, we use a softer, lime-rich mortar.

For most chimneys, the same group recommends Type N portland cement-lime mortar, with both weather and heat in mind. Brick that stays wet can crack or spall under repeated freeze-thaw cycles, another of its notes says. The group also calls repointing one of the most effective ways to cut down on water getting in.

Fresh gray mortar joints on a repointed brick chimney beside white roof trim, chimney tuckpointing Gloved hand pressing mortar into a brick joint with a pointing trowel and a hawk of mortar, chimney tuckpointing

Ready to get started?

Call or text for a written quote anywhere across Racine County, Kenosha County and the south side of Milwaukee County.

(262) 744-4688
How We Work

How a Job With M.O.E Masonry Runs

From the first call or text to the finished work, here is how it goes.

1

Call or text

Call or text (262) 744-4688 and tell us about the job. Photos help, so send a few if you can.

2

We look at the job

We come out and look at the masonry and the mortar joints. Good photos can stand in for that first look.

3

The written quote

You get the quote in writing, with the work spelled out. Once you say yes, we set a start date.

4

The work

The brick, block or stone is delivered to the site, and scaffolding goes up where the height calls for it. Then we lay the new masonry or make the repair.

5

The finish

We take a final look at the work with you. The site is cleaned up before we leave.

FAQ

Chimney Tuckpointing Questions, Answered

Common questions about chimney tuckpointing across Racine County, Kenosha County and the south side of Milwaukee County. If yours is not here, call or text and ask.

Call (262) 744-4688

How much does chimney tuckpointing cost?
The price turns on how many joints are worn, how deep, and whether we repoint spots or the whole stack. Roof pitch, chimney height and any spalled brick add to the work. We look at the chimney, or you send photos, and put the quote in writing. For market ranges, see our chimney repair cost guide.
Does my chimney need tuckpointing or a rebuild?
If the brick is sound and only the joints are worn, chimney tuckpointing is the fix. Loose top courses, widespread spalling or a cracked crown point to a bigger repair or a rebuild. Once we see the chimney or your photos, we tell you which job it is.
Do you sweep or inspect chimneys?
No. Chimney sweeping, cleaning and flue inspections are a chimney sweep's work. Liners are another trade's job, and the flashing at the roof is a roofer's. If a sweep's report notes open joints or spalled brick, send it to us for a written quote.
Should I seal my chimney after tuckpointing?
Water-repellent sealers are another trade's product. A Brick Industry Association note warns that salts trapped inside coated brick can build pressure and spall it. Sound joints and a sound crown are the masonry side of keeping water out.
How long does chimney tuckpointing last?
National Park Service guidance says a good repointing job is meant to last at least 30 years. A Brick Industry Association note adds that chimneys take harsher weather than walls and may need repairs sooner. How long yours lasts depends on how wet the chimney stays.
Can chimney tuckpointing be done in winter?
Wisconsin's dwelling code requires cold-weather procedures for masonry work below 40 degrees F. Around Racine, that makes spring through fall the season for chimney tuckpointing. Winter work is scheduled by the weather.
More From M.O.E Masonry

Work That Pairs With Chimney Tuckpointing

Brick chimney above a roofline with loose, crumbling top courses and open mortar joints, chimney repair

Chimney Repair

We repair and rebuild brick chimneys around Racine, with brick and mortar matched to the old. New crowns and rain caps are part of the work too.

Learn More
Hand pressing new mortar into brick joints with a tuck pointer, tuckpointing

Tuckpointing

We grind out crumbling mortar joints and pack in new mortar matched to the old. We tuckpoint brick, block and stone walls, chimneys, foundations and steps around Racine.

Learn More
Red brick front steps, landing and walk with black iron railings at a brick house, masonry repair

Masonry Repair

Spalled brick, rusted lintels, loose steps and failed wall sections repaired and matched to the wall. Historic brick buildings and churches restored with matching brick and mortar.

Learn More
Why Choose M.O.E Masonry

Brick, Block and Stone Masonry Around Racine

Brick, block and stone

We lay all three, for new work and for repairs. You deal with one masonry company, whatever the wall is made of.

Mortar and brick matched

A repair should look like part of the wall. We match the mortar to the old joints and pick brick to match the wall around it.

A written quote after we look

We look at the job before we price it, in person or through your photos. The quote comes to you in writing before any work starts.

Based in Mount Pleasant

Mount Pleasant sits on the south side of Racine, in Racine County. From there, we work in Racine, Kenosha and the south side of Milwaukee County.

Guides and Resources

Chimney Tuckpointing Guides

Request a Quote

Get In Touch With M.O.E Masonry

Tell us about the job and where it is, and send photos if you have them. Call or text (262) 744-4688, or use the form, and we will get back to you.

  • Call or text (262) 744-4688
  • Mount Pleasant, WI · serving Racine County, Kenosha County and the south side of Milwaukee County
  • Written quotes · brick, block and stone, new work and repairs

Request a Quote

Tell us about the wall, chimney, foundation or steps and where the job is. We look at it and put the quote in writing.

Call (262) 744-4688