Block Foundations
Concrete block foundations and frost walls for new houses, additions, garages and outbuildings. Block foundation repair on the masonry side: tuckpointing, new block, parging and rebuilt sections.
Learn More
Parging is a coat of portland cement mortar troweled over the outside face of a foundation wall. On a concrete block foundation, it covers the band of block you see above the ground. When that parge coat cracks, sounds hollow, flakes or goes missing, M.O.E Masonry takes off the loose parging. A new coat goes on in layers and cures. We also parge the exposed band of poured concrete foundation walls, and new block foundation walls as we lay them.
Repairs underneath come first. Open mortar joints get tuckpointing, and spalled or broken block is replaced as part of block foundation repair. We are based in Mount Pleasant on the south side of Racine and work about 40 miles around it. Call or text (262) 744-4688. We look at the wall or your photos and put the quote in writing.
Tell us about the wall, chimney, foundation or steps and where the job is. We look at it and put the quote in writing.
Wisconsin's Uniform Dwelling Code calls for parging on new block foundation walls (SPS 321.18). It goes on the outside of the wall, from the footing to finished grade. The minimum is 3/8 inch of Type M or S portland cement mortar.
The same section then calls for a continuous dampproofing coat over the parging. The code skips the parging in two cases, both tied to the dampproofing product. The parging is not the dampproofing.
The block industry's technical note lets the outside joints of a new wall be struck flush when parging will follow. It has the parge coat beveled at the top to shed water and thickened into a cove at the footing.
Census estimates put the median year built of the City of Racine's homes at 1953, the mid-century block foundation era. The block industry's maintenance note says coated block walls need their coating checked from time to time. At some point, it adds, the coating has to be redone.
Parge coat repair starts with taking off everything cracked, hollow or loose. Coatings go on clean, structurally sound walls, the industry's technical note says. Dirt, oil and efflorescence come off because they can weaken the bond. Then the wall is dampened.
The new parging goes on in two coats, as the maintenance note describes. The first, about 1/4 inch thick, is left rough so the finish coat bonds to it. The finish coat, also about 1/4 inch, goes on once the first is thumbprint hard. The new coat is kept moist for its first few days while it cures.
Old stone foundations get no cement parge coat from us. The Wisconsin Historical Society says early stone foundations were laid with lime-based mortar. It says any coating on the inside of a stone wall prevents the normal migration of moisture. It says to remove loose cement or paint and let the rest flake off over time.
The National Park Service says a straight portland cement and sand mortar is extremely hard and resists water movement. New mortar must be softer and more vapor permeable than the masonry, it adds. Those walls get stone foundation repair instead.
We do not sell parging on the inside of a damp block wall as a fix. Stopping water from the soil is a waterproofing company's work, such as drain tile or a sump pump. A crack that shows bowing or movement goes to a structural engineer first. A parge coat over a moving crack cracks again.
Call or text for a written quote anywhere across Racine County, Kenosha County and the south side of Milwaukee County.
(262) 744-4688From the first call or text to the finished work, here is how it goes.
Call or text (262) 744-4688 and tell us about the job. Photos help, so send a few if you can.
We come out and look at the masonry and the mortar joints. Good photos can stand in for that first look.
You get the quote in writing, with the work spelled out. Once you say yes, we set a start date.
The brick, block or stone is delivered to the site, and scaffolding goes up where the height calls for it. Then we lay the new masonry or make the repair.
We take a final look at the work with you. The site is cleaned up before we leave.
Common questions about parging across Racine County, Kenosha County and the south side of Milwaukee County. If yours is not here, call or text and ask.
Concrete block foundations and frost walls for new houses, additions, garages and outbuildings. Block foundation repair on the masonry side: tuckpointing, new block, parging and rebuilt sections.
Learn More
We repoint open and sandy joints in old stone foundations with mortar matched to the old. We also reset loose stones and replace broken ones in fieldstone and limestone walls around Racine.
Learn More
We grind out crumbling mortar joints and pack in new mortar matched to the old. We tuckpoint brick, block and stone walls, chimneys, foundations and steps around Racine.
Learn MoreWe lay all three, for new work and for repairs. You deal with one masonry company, whatever the wall is made of.
A repair should look like part of the wall. We match the mortar to the old joints and pick brick to match the wall around it.
We look at the job before we price it, in person or through your photos. The quote comes to you in writing before any work starts.
Mount Pleasant sits on the south side of Racine, in Racine County. From there, we work in Racine, Kenosha and the south side of Milwaukee County.

Poured vs block foundation in Wisconsin: how each wall is built, what the state code asks, market costs from national guides and cracks to watch.
Read more →
What stair-step, vertical and horizontal cracks in a block foundation mean in southeast Wisconsin, who fixes each one, and what repairs cost.
Read more →Tell us about the job and where it is, and send photos if you have them. Call or text (262) 744-4688, or use the form, and we will get back to you.
Tell us about the wall, chimney, foundation or steps and where the job is. We look at it and put the quote in writing.